6PCS DRV8833 Dual DC Stepper Motor Driver Module H-Bridge Board Compatible with Arduino TB6612

Feature: Size: 18*21mm, weight: 3g Input voltage: 2.7V-10.8V Single H-bridge output current: 1.5A, can drive 2pcs DC deceleration motors Built in overcurrent protection, short circuit protection, undervoltage lockout, and overheat protection. With low-power sleep mode. Use: can drive DC motors below 1.5A and 4-wire stepper motors. DRV8833 Pin description: ANI1: The logic input control port of AO1, with a voltage level of 0-5V. AIN2: The logic input control port of AO2, with a voltage level of 0-5V. BNI1: The logic input control port of BO1, with a voltage level of 0-5V. BIN2: The logic input control port of BO2, with a voltage level of 0-5V. AO1 and AO2 are 1-channel H-bridge output ports, connected to two pins of a DC motor. BO1 and BO2 are 2-channel H-bridge output ports, connected to the two pins of another external direct motor. GND: Ground. VM: Chip and motor power supply pins, voltage range 2.7V – 10.8V. STBY: Grounded or suspended chip does not work, no output, connected to 5V for operation; Level 0-5V. NC: Empty feet.

• Input voltage: 2.7V-10.8V
• Single H-bridge output current: 1.5A, can drive 2pcs DC deceleration motors
• Built in overcurrent protection, short circuit protection, undervoltage lockout, and overheat protection. With low-power sleep mode
• Use: can drive DC motors below 1.5A and 4-wire stepper motors.
• Basically compatible with TB6612 module pins.